Post Process turns a 3D part into an Art looking

Project Introduction

When crafting with FDM printer, designers sometimes will feel bound by the material. Currently, FDM printer mainly uses thermoplastic as raw material to print stuff and the surface texture is always the same. However, with post process, the printed model can be more colorful and even has a metal texture.

Print the model

For this project, we use a squirrel model as an example. After sliced by 3DStar software, the model was saved in a USB drive and load into the Einstart-C printer. Couple of hours later, a beautiful squirrel was printed and ready for post process.

Postprocess1

Polish the Surface

Surface polish is necessary for later coloring. A fine sand paper can help smooth the surface.

Postprocess2

Coloring

Acrylic paint was used for coloring in this project. It has a strong bond with the PLA model surface. To paint the model, the first step is to apply a black base. Use black acrylic paint to cover the whole model evenly.Postprocess3

Postprocess4

Wait for the base paint to dry and then apply bronze paint. Dry up the bronze paint a little bit before painted onto the model. This will prevent the paint flowing into detailed place and ruin the texture. Gently brush the surface so that the paint only apply to the protruding area.

Postprocess5

Postprocess6

Finally, apply varnish paint to shine the surface and create a metal reflective effect. Also, varnish can help protect other paint layers.

Postprocess7

With post process, it is possible to use a low-cost desktop printer to create wonderful art with different textures.

Postprocess8

Leave a Reply